Caution!
Depending on the condition of the moisture-proof box, there may be resistance to the rotation of the drum.
In that case, adjust the slicer to shorten the overall length of (Fila_Case_Drum_B.stl) by about 3 mm.
In the opposite case, if you want resistance to the rotation of the drum, follow the same procedure to extend it by about 2 mm.
This auxiliary stand is compatible with commercially available filament moisture-proof boxes for 3D printers.
This was devised because the force required to pull out the filament is excessive in the standard state that it was purchased in.
It uses the two bearings and one pipe that come with the filament moisture-proof box.
It is a loose fit except for the part where the rack meshes.
The height of the axis can be adjusted up and down.
If you set it as high as possible so that the lid can close, the internal parts will not come apart even if the box tips over.
Support is only required if the drum is to be printed upright.
| Fila_Case_Drum_B.stl | 1.7MB | |
| Fila_Case_Piece_B2.stl | 306.4KB | |
| Fila_Case_Stand_B.stl | 3.0MB |
