Automatic Rubber Band Turret 3D Printer Model Free Download

Description Files (14)

Summary

This rubber band turret can be laser cut and 3d printed, or just 3d printed (3DP_ files are the ones to replace the lasercut ones).
Its good for firing small rubber bands

For assembly, refer to the pictures or Fusion 360 file. This guide is useful for the laser cut version: https://imgur.com/r/diy/gir8c
The base is not included, its just a 10cm diameter circle.
I have only tested the laser cut version, so you may need to file down the 3d printed parts that replace the laser cut ones a bit.

You will need:

Sandpaper - for rounding off the teeth at the back to make the rubber bands slide to the next tooth better, as well as sanding down the thickness of the sliding piece so it does so smoothly
2x SG90 9g Servo motors + servo horn + screws for servo arm
2x M3x15 bolts + M3 nuts for attaching the sensor mount and swivel mount
M3x10 bolt + M3 nut for the firing mechanism
2x M2x15 bolts + M2 nuts for the firing servo
Superglue, the whole thing is mostly glued together, as you can't put screws in the top holes, they would interfere with the rubber bands
Flush cutters for trimming servo horn
(optional) HC-SR04 Distance sensor
(optional) single core wire for attaching the distance sensor to the holes in the sensor mount
Arduino etc to control the motors and read the sensor

The design is based on this https://www.instructables.com/Semi-Automatic-Rubber-Band-Gun/

3DP_lever.stl	37.0KB
3DP_middle.stl	41.3KB
3DP_middle_firing_mechanism.stl	35.3KB
3DP_side_left.stl	87.2KB
3DP_side_right.stl	84.7KB
lever.dxf	3.2KB
middle.dxf	18.9KB
mount.stl	31.7KB
rubber_band_turret_3_v11.f3d	2.8MB
rubber_band_turret_3_v11.step	4.1MB
sensor_mount.stl	46.8KB
servo_base.stl	76.6KB
side_left.dxf	16.9KB
side_right.dxf	22.1KB

Automatic Rubber Band Turret 3D Printer Model

Summary

Tags

You might also like