Auto Adjusting Phone Holder 3D Printer Model
The file 'Auto Adjusting Phone Holder 3D Printer Model' is (stl) file type, size is 718.8KB.
The file 'Auto Adjusting Phone Holder 3D Printer Model' is (stl) file type, size is 718.8KB.
Print with support the following parts:
I advise printing the vent holder with TPU, or any soft material to avoid scratching your car vents.
You can add a rubber band so that it stays open when your phone is not in place.
Flaw: the clips are not that strong, be gentle while assembling. I added glue on the top of the clips to make sure they last once in place.
I designed it for my phone (iPhone 8 size). Even though it's adjustable, I don't know if it works with large phones.
Feel free to give any feedback!
| back_v35.stl | 736.7KB | |
| bottom_end_v14.stl | 61.3KB | |
| link_1_support_v27.stl | 149.1KB | |
| link_1_upper_v24.stl | 191.5KB | |
| link_2_support_v11.stl | 159.0KB | |
| link_2_upper_v18.stl | 230.2KB | |
| side_support_fat_v21.stl | 151.5KB | |
| side_support_slim_v9.stl | 134.8KB | |
| vent_holder_v12.stl | 559.8KB |
