Audi VW Wheel Alignment Camber Toe Tool 5×112 3D Printer Model
The file 'Audi VW Wheel Alignment Camber Toe Tool 5×112 3D Printer Model' is (stl) file type, size is 997.0KB.
The file 'Audi VW Wheel Alignment Camber Toe Tool 5×112 3D Printer Model' is (stl) file type, size is 997.0KB.
Scale up by 25.4!(if i remember right)
This is an alignment tool for VW, Audi and any other car with 5x112 bolt pattern. To use this u will need a laser level and something to prop it up on. This is made to hold the harbor freight angle finder on the bottom to give you a camber reading. There are 2 lines on the face of the tool that are specific to the Audi A6, they are spaced .6" apart because the Audi has a wheelbase 1.2" wider in the rear. To use that properly you need to set up the laser lever so the laser hits the outside line on the front and the inside line on the back.
You will need to print:
2x AlignmentGaugeNew
2x AlignmentFlange
6x AlignmentLugAdapter
6x AlignmentNut
and all you need to put it together is any small nut and bolt combo you can find laying around.
hint: to make it easy you should put the lug adapters on first then throw the rest on the adapters.
| AlignmentFlange.stl | 232.2KB | |
| AlignmentGaugeNew.stl | 148.7KB | |
| AlignmentLugAdapter.stl | 1.5MB | |
| AlignmentNut.stl | 208.7KB |
