ATX PSU Mount 3D Printer Model
The file 'ATX PSU Mount 3D Printer Model' is (stl) file type, size is 23.8KB.
The file 'ATX PSU Mount 3D Printer Model' is (stl) file type, size is 23.8KB.
Just a mount for an ATX PSU for my Prusa i3 (Hesine) printer.
But, before you read further, check the "Power and Controller mounting for Makerfarm Prusa i3" by moczys, http://www.thingiverse.com/thing:620172.
I saw it only when I was about to publish this one and I find it much nicer, more elegant.
I would have adapted it to my needs, if I had seen it earlier.
The PSU is a BeQuiet PSU Power 7 300W, but the mount should be ok for some others with the overall measurements of 86 x 150 x 140mm.
Check also the ventilation openings etc.!!
The mount should be ok for other printers too but the holes correspond to the ones that are already in my printer.
I made the holes a bit spacious for the 3mm bolts needed, to allow for a bit of variation, so some washers wouldn't go amiss.
Those things under the bottom are supports for some tie-wraps or such.
The thin stiles in the bottom-holes should afterwards be removed.
| PSU-mount.stl | 109.9KB |
