1 recomendated PETG
2 asemble GPS mount need superglue
3 motormount filling 100% recomendated. The wood will have to be removed.
4 cage nuts in the backing are glued with superglue and baking soda (for quick drying)
5 CRSF the antenna does not stick out from the bottom )))
6 VTX ATTENTION. I do not know how well the antenna will work in this model. On other models, installing the pagoda upside down works well. Lolipop-type antennas do not work well for me upside down. I recommend using the pagoda antenna. Attention, the antenna will have to be shortened a little in order for it to fit.During tests, the picture flew 3.5 km, the picture is satisfactory
7 ESC There is thermal paste between the mosfets and the aluminum plate! When tested at full throttle at a current of 45A, lasting 10 seconds, the temperature did not rise above 50°C. The air temperature was +1°C. During a calm flight (10-15A), the temperature is about 35°C
8 Additional magnets. The force to open the lid is doubled, up to 1.2 kg. But it is important to glue the magnets correctly
For best results:
1) Glue magnets on superglue
2) Glue part 1 to the fuselage and let the glue dry
3) Install part 2 on part 1 (connect magnets)
4) Apply glue to part 2
5) Close the lid and let the glue dry
| crsf1.stl | 2.4MB | |
| crsf2.stl | 176.3KB | |
| crsf_3.stl | 396.2KB | |
| crsf_box1.stl | 46.1KB | |
| crsf_box2.stl | 32.7KB | |
| FC_mount.stl | 119.4KB | |
| gps1_need_superglue.stl | 33.6KB | |
| gps2need_superglue.stl | 33.6KB | |
| gps_bn280.stl | 4.4KB | |
| mag_back_d10xh2.7.stl | 93.2KB | |
| mag_front_d10mm_h2.7mm.stl | 391.1KB | |
| motormount_1.stl | 326.5KB | |
| moto_16mm.stl | 954.3KB | |
| moto_16x19.stl | 953.9KB | |
| moto_19mm_2.stl | 689.6KB | |
| moto_19mm_3.stl | 947.2KB | |
| noze1.stl | 4.2KB | |
| noze2.stl | 16.7KB | |
| pagoda1.stl | 415.6KB | |
| pagoda2.stl | 278.2KB | |
| vtx1.stl | 64.1KB | |
| vtx2.stl | 36.0KB | |
| vtx3.stl | 36.0KB |
