The ASA Carbon Monoxide Detector Tab used by many in General Aviation, has a hard time sticking to many panels and surfaces, the adhesive strip it comes with comes off in the heat of the cockpit and we find them on the floor.
This holder can be attached to the panel with a command or other adhesive strip, (or you could screw it if you REALLY wanted to) and then the detector tab just slides inside holding it secure to the panel but making it very easy to see and replace.
I printed it in PLA, and there is enough tolerance in the design the handle the effects of heat/cold cycling on the PLA.
disclaimer: technically, not for use in certified aircraft only for experimental and/or home build aircraft.
| ASA_CO_Holder_1.stl | 2.2KB |
