Articulating Arm With Customizable End 3D Printer Model
The file 'Articulating Arm With Customizable End 3D Printer Model' is (stl) file type, size is 10.6KB.
The file 'Articulating Arm With Customizable End 3D Printer Model' is (stl) file type, size is 10.6KB.
UNFINISHED WORK
STILL NEEDS A CLAMP FOR THE BOTTOM
The part is about 8ish inches tall and printing 3 is recommended for desired height.
Print laying flat so layer lines run across the whole length of the part.
Print Diagonal across print bed to ensure complete fit.
5-6 Walls & Top/Bottom
20-25% Infill
Required Hardware
1/4-20 by 1.25 in or longer, holes for bolts are 1/4 in in diameter and may be a tight fit sanding may be required.
1/4-20 Nuts are also required for the bolts/ Wing Nuts are an option however they are not recommended because they are untested.
Assembly
Slide the 2 parts slots into each other until hole can be seen all the way through, sanding may be required. Then insert 1/4-20 bolt then tighten nut until 2 parts support their weight and do not move.
| articuatingarmmainarm.stl | 61.8KB |
