Articulated Hand Remix 3D Printer Model
The file 'Articulated Hand Remix 3D Printer Model' is (stl) file type, size is 3.3MB.
The file 'Articulated Hand Remix 3D Printer Model' is (stl) file type, size is 3.3MB.
For Sophie's non-robotic hands, I took the 'Jointed Hand' by bq3D and scaled it down by about 20%.
The finger parts are very small and benefit from being printed on a raft (to prevent warping at the base) at fine or extra-fine (0.06mm) resolution. This way the internal channels are better formed. No supports are needed though, because they are already built-in.
I found that the internal channels of the hand were too small for doll elastic to fit through, so i had to cut the 3d mesh of the palm into three separate pieces, then used a drill-bit to widen the internal channels of each piece. I also widened the holes of each finger part using a very small 2mm drill bit. After this, I managed to fit the hand together by using very thin, steel gardener's wire.
| Index_Base.stl | 278.5KB | |
| Index_Middle.stl | 313.4KB | |
| Index_Tip.stl | 713.1KB | |
| Middle_Base.stl | 366.0KB | |
| Middle_Mid.stl | 424.6KB | |
| Middle_Tip.stl | 959.7KB | |
| Palm_Base.stl | 78.7KB | |
| Palm_Middle.stl | 95.4KB | |
| Palm_Top.stl | 104.0KB | |
| Pinky_Base.stl | 337.8KB | |
| Pinky_Middle.stl | 352.4KB | |
| Pinky_Tip.stl | 891.0KB | |
| Ring_Base.stl | 373.6KB | |
| Ring_Middle.stl | 394.3KB | |
| Ring_Tip.stl | 645.1KB | |
| Thumb_Base.stl | 368.7KB | |
| Thumb_Tip.stl | 600.2KB |
