Various parts for an Armattan MRP 130:
1) I like having a plate to mount my VTX to and not just trying to stick it on some rails, and that plate can make a convenient mount for other video related items like LC Filter parts or a Micro MinimOSD.
2) I don't like using zip ties and heat shrink for antennas - they can still get sucked into props in crashes and they just look unfinished at best. So here are some antenna mounts that accept DuBro antenna tubes. Drill out as appropriate, they work on either the upper or lower M3 screws on the pod. My printer prints best with them in an unusual orientation, but if you have a higher quality printer you might be better off printing them so the tube is vertical and the bracket isn't. Experiment, they're tiny and shouldn't take that long to print even with high quality settings.
3) A largish flat plate to mount a couple of strip LEDs to for orientation / mount your OSD to / etc. Should fit both the original plate and the extended side plate.
| Armattan_MRP_130_Antenna_Mount_20x45_Left__Right_Nose_Down_thicker.stl | 711.4KB | |
| Armattan_MRP_130_Antenna_Mount_20_Left.scad | 1.5KB | |
| Armattan_MRP_130_Antenna_Mount_20_Left.stl | 354.9KB | |
| Armattan_MRP_130_Antenna_Mount_20_Right.scad | 1.3KB | |
| Armattan_MRP_130_Antenna_Mount_20_Right.stl | 353.8KB | |
| Armattan_MRP_130_LED_Bar.scad | 459.0B | |
| Armattan_MRP_130_LED_Bar.stl | 8.4KB | |
| Armattan_MRP_130_VTX_Holder.scad | 1.3KB | |
| Armattan_MRP_130_VTX_Holder.stl | 59.2KB |
