Been searching for solutions to pimp up my chaos bag for a while, and i'm not a fan of the coin capsules everyone else is using, so after stumbling upon something similiar over etsy i thought about modeling my own version.
This is a token chip for chaos tokens, fits the stock cardboard tokens precisely and the two halves are joined via snap fit pegs on a very tight and effective solution with no glue needed, also they can be easily opened if you need to take the tokes out of them.
Make sure to print these in pla as petg is not that good in printing such small things (pegs are very tiny), print two halves for each token (88 pieces for 44 tokens total).
My settings for pla were 2 perimeters and .20 layer height. Make sure your extruder is well calibrated as the fitting is very tight and you may end up flush or too tight depending on how much you're under/over extruding.
Enjoy!
| AHLCG_CHAOS_BAG_TOKEN_CHIP.stl | 212.6KB |
