This is Version 1.0 of my throttle quadrant.
**MAKE SURE YOU LAY FLAT THE PARTS BEFORE SLICING
Features:
-Magnetic Hall Sensors (allegro 1302)
-Ball Bearings
-Friction Adjustment (With a Hot Glue Brake)
-Horizontally stackable throttle mechanisms
You will need:
-1 x Piece of metal 5x9x1-ish mm to go between the middle section of the mechanism and the hot glue brake
-1 x Arduino Pro-Micro (or other USB compatible HID board)
-6 x MF126zz ball bearings
-Assorted Switches and buttons (i dont know how to ID them)
-Assorted Screws and nuts (i'm sorry i dont know how to ID screws, so a little help is welcome)
-6 x n52 5x3mm neodymium magnets
-3 Allegro 1302 Hall Sensors
The Bottom spacer and the box you could change, i mainly post this for the mechanism
Print everything but the box parts at 0.2 mm
Sand the shaft and Box wall joints for good fit
Oil the HotGlueMold before filling with Hot Glue
*Pet-Wolf Not Included
Hope this helps some Flight simmers out there!
| BackBody.stl | 380.2KB | |
| BackPlate.stl | 34.5KB | |
| BothHandlesBack.stl | 655.5KB | |
| BottomPlate.stl | 277.7KB | |
| FrontPlate.stl | 33.5KB | |
| HotGlueBrakeMold.stl | 34.8KB | |
| LeftPlate.stl | 33.5KB | |
| Lever.stl | 205.9KB | |
| MagnetHolder.stl | 142.5KB | |
| MainHandleFront.stl | 1.6MB | |
| MidBody.stl | 233.7KB | |
| OptionalBottomSpacer.stl | 36.8KB | |
| RightPlate.stl | 33.5KB | |
| SecondaryHandleBack.stl | 699.2KB | |
| SensorBody.stl | 443.8KB | |
| Shaft.stl | 157.5KB | |
| TopPlate.stl | 446.2KB |
![Flexible Mask Rolley [ Universal Modular System ] Covid-19 3D Printer Model](https://cdn.3axis.co/assets/f7/31/be/6f/f731be6f-f84e-41f9-b8e7-521a31e3da08/images/d5984296-9fb9-411d-aef5-41e100cd5934_thumb.jpg)
