Three-piece Arduino Mini holder with multple upper assembly variation. Three upper variations inlclude a single LED holder, a triple LED holder, and a circuit board holder. Clamps the tiny board in place, and also supports it from the bottom using double sided tape (best case is to use the thinnest you can find). Cable routing notches are cut around the holder to organize the work. Assembly is intended to be attached inside an electronics box, or surface-mounted on acrylic.
Point is to hold the board in place while working on it, without affecting the space needed to accomodate the bundle of wires that attach to it; to provide the ability to hold the Mini in place and organize your work as you go; and then to make it look decent when you attach it to something.
| arduino_mini_holder.skp | 2.5MB | |
| arduino_mini_holder_lower_gap_4_res_8_dec_8.stl | 385.9KB | |
| arduino_mini_holder_middle_gap_4_res_8_dec_8.stl | 625.1KB | |
| arduino_mini_holder_upper_gap_4_res_8_dec_8.stl | 386.9KB | |
| Middle.zip | 221.5KB | |
| Upper.zip | 129.7KB |
