Arcs Full Box Organizer (w/ Leaders And Lore) V1.3 3D Printer Model
The file 'Arcs Full Box Organizer (w/ Leaders And Lore) V1.3 3D Printer Model' is (stl) file type, size is 823.9KB.
The file 'Arcs Full Box Organizer (w/ Leaders And Lore) V1.3 3D Printer Model' is (stl) file type, size is 823.9KB.
EDIT:
V1.3 - Per feedback, I've added an alternate version of the player tray with slightly thinner walls. If the tolerance between the lid and the tray is too tight, use that instead.
V1.2 - Per feedback, I've widened the gaps on the resource token tray, to make the tokens easier to grab. The new file has replaced the old one.
V1.1 - I've added a box for rolling the dice, that sits on top of the resource token tray during transport.
This is a complete organizer for retail version of Arcs, plus the Leaders and Lore expansion. (It is designed for the wooden pieces.)
Each player gets their own token tray, and there's a central organizer for the resource tokens.
The card holders will work with sleeved cards, though you may need to spread out the bigger card sets between two holders.
The token box lid and base will likely need supports, as there are some overhangs - though you could try without if your bridging is good. I used tree supports and everything came out clean.
To pack, put the cards and resource tokens on the bottom layer, with two card spacers to hold everything tight. Then put the board, player boards and all rules in the middle, with the board spacer. Finally, put the player trays, token tray and dice tray on the top.
Everything will fit nicely and the box should sit flush!
| Board_Spacer_Final.stl | 1.4KB | |
| Card_Spacer_x2_Final.stl | 263.9KB | |
| Center_Storage_Final_v1.1.stl | 1.0MB | |
| Dice_Box_Final.stl | 241.2KB | |
| Dice_Tray_Final.stl | 143.7KB | |
| Leaders_Card_Holder_Final.stl | 165.5KB | |
| Player_Pieces_x4_Final.stl | 310.9KB | |
| Player_Pieces_x4_Top_Final.stl | 280.8KB | |
| Standard_Card_Holder_x4_Final.stl | 120.2KB | |
| Thin_Wall_Box_Alternate_Final.stl | 310.9KB | |
| Token_Box_Base_Final.stl | 146.0KB | |
| Token_Box_Lid_Final.stl | 5.7KB |
