Needed a better way of holding coins for the arcade, or for the wash - based loosely on this thing but it didn't have all the features I wanted. Any coin that is similar to a quarter in dimensions should work, but probably not too much smaller as you would still need to fish it out with your thumb.
Small markings denote a dollar in quarters, larger markings around the sides denote 5 dollars. Total capacity should be around 11-13 dollars depending on the compression of the springs you place.
Required:
Printing:
Print one of each model for full assembly; .15mm or lower is recommended for layer-height. Large layer heights might make it difficult to screw the end-cap on or might cause issues getting quarters into the slot.
| ch_cap.stl | 241.2KB | |
| ch_double_spacer.stl | 336.8KB | |
| ch_fullbody.stl | 235.9KB | |
| ch_single_spacer.stl | 224.1KB |
