This is my version of an arcade joystick with a built-in raspberry pi 3. The hard disk holder is optional and can be attached to the base.
My printing platform is relatively small 20x21cm and I have had to split the main part, If your platform is bigger you can print the whole piece.
If the green lines do not enter try to fit them gently with a hammer.
Electronics:
| body.stl | 409.1KB | |
| body_part1.stl | 193.2KB | |
| body_part2.stl | 217.3KB | |
| hd_holder.stl | 49.7KB | |
| lines.stl | 30.2KB | |
| pi_arcade.dwg | 1023.5KB | |
| top.stl | 257.2KB | |
| top_part1.stl | 133.0KB | |
| top_part2.stl | 130.9KB |
