This is an example of an arbor press. It was designed in a class at Purdue. I have included the assembly drawing so you can see where everything goes for the most part. There are standard parts in this project that you could buy instead of printing. I would recommend that you buy them so it fits together better. Be careful printing the parts that have threads.
| 90181A537_25_20_5_STEEL_THUMB_SCREW.stl | 188.2KB | |
| 90760A200_10_32_STEEL_NARROW_HEX_NUT.stl | 167.0KB | |
| 92620A541_25_20_875_HEX_HEAD_SCREW.stl | 532.8KB | |
| 94105A824_10_32_1875_FLAT_POINT_SOCKET_SET_SCREW.stl | 59.2KB | |
| 94355A229_10_32_625_FLAT_POINT_SOCKET_SET_SCREW.stl | 626.4KB | |
| 98400A334_25_1_GROOVED_DOWEL_PIN.stl | 52.1KB | |
| Arbor_Press_Assembly.iam | 1.3MB | |
| Arbor_Press_Assembly.idw | 917.5KB | |
| Arbor_Press_Assembly.pdf | 202.7KB | |
| Arbor_Press_Assembly.stl | 2.4MB | |
| Collar.idw | 201.5KB | |
| Collar.pdf | 76.3KB | |
| Collar.stl | 10.1KB | |
| Face_Plate.idw | 231.0KB | |
| Face_Plate.pdf | 79.2KB | |
| Face_Plate.stl | 58.5KB | |
| Frame.idw | 520.0KB | |
| Frame.pdf | 115.2KB | |
| Frame.stl | 371.8KB | |
| Gib_Plate.idw | 180.5KB | |
| Gib_Plate.pdf | 69.6KB | |
| Gib_Plate.stl | 684.0B | |
| Handle_Cap.idw | 198.0KB | |
| Handle_Cap.pdf | 76.0KB | |
| Handle_Cap.stl | 10.2KB | |
| Lever_Arm.idw | 226.5KB | |
| Lever_Arm.pdf | 79.3KB | |
| Lever_Arm.stl | 440.5KB | |
| Pinion_Shaft.idw | 259.5KB | |
| Pinion_Shaft.pdf | 86.6KB | |
| Pinion_Shaft.stl | 90.6KB | |
| Ram.idw | 195.0KB | |
| Ram.pdf | 71.9KB | |
| Ram.stl | 17.9KB | |
| Table_Plate.idw | 197.0KB | |
| Table_Plate.pdf | 77.5KB | |
| Table_Plate.stl | 31.7KB |
