AR Wall Mount - Single Mag
---Horizontal---
"The Minuteman"
Features:
- Single Mag Holder
- Gear Hook. Belts, Bag, Mag Carrier etc
- 1/4" Cable Lock Hole
- Ambi Magwell Mounting - both ways
- Notch for mag catch has a built in Print Supports on both sides (No bed supports needed)
Improvements that make this one different:
- Layer Sticks to prevent snapping on layer lines. (Allows for a little lighter infill and walls but increases strength and durability)
- Beefy Design
Needed:
3 Drywall Screws
2 General purpose wood screws, sized appropriately for hook.
Post Processing:
- Depending on your printer flow and accuracy, you will need to sand the sticks until they can be inserted about an inch or more easily. Then nail them in with a hammer. You only get one chance. No glue needed. If you get stuck, a heat gun is your friend.
Enjoy
