Apple Watch IPhone IPad Charger 3D Printer Model
The file 'Apple Watch IPhone IPad Charger 3D Printer Model' is (stl) file type, size is 518.6KB.
The file 'Apple Watch IPhone IPad Charger 3D Printer Model' is (stl) file type, size is 518.6KB.
This is roughly based off of the Watch / iPhone charger dock I did. I was asked to make one to also charge an iPad Mini so I did. Once printed, run the Apple Watch charger USB plug down through the hole. Glue the charger into the circular cut out and run the cable along the trench in the bottom. Run the iPhone and iPad charging cables up through the bottom, plug them into the device then carefully glue them in place so that the charging cable to plug in even with a case on. Run the cables in the bottom trenches as well.
| Apple_Watch_iPhone_iPad_Charger.stl | 1.3MB |
