Apple Magic Keyboard Angler 3D Printer Model
The file 'Apple Magic Keyboard Angler 3D Printer Model' is (stl) file type, size is 443.0B.
The file 'Apple Magic Keyboard Angler 3D Printer Model' is (stl) file type, size is 443.0B.
I needed a SLIGHT angle on my Apple Magic Keyboard, so I designed this and attached it with hot glue. I also put some grippy rubber on the bottom so it wouldn't slide around. The angle on the keyboard with this print is PERFECT. Just print two of them and place far enough apart to support the keyboard. Been using my keyboard with these supports for many months and they remain perfect. Very simple print as well.
The angle in the image looks steeper then it is ... the length of this is slightly over half the top to bottom length of the keyboard. It only lifts the back of the keyboard by about 14mm
| Magic_Keyboard_Angler.stl | 1.3KB |
