Apple Mac Studio Accessory Drawer 3D Printer Model
The file 'Apple Mac Studio Accessory Drawer 3D Printer Model' is (stl) file type, size is 31.9KB.
The file 'Apple Mac Studio Accessory Drawer 3D Printer Model' is (stl) file type, size is 31.9KB.
Mini Mac Studio Accessory Drawer
This was a project I designed in Tinkercad, sliced in Cura, and printed on a Creality CR6-SE.
I designed this little accessory drawer to sit on my desk and match the look of my new Mac Studio computer. I had a few goals in mind:
I needed convenient access to USB-A ports. I designed this around the a well-reviewed USB hub I picked top from Amazon. The Inateck USB Hub with 4 USB A Ports, USB 3.2 Gen 2 Speed, 50cm Cable, HB2025A.
I wanted it to hold my Sandisk Extreme portable SSD and have room to add another SSD down the line. I left the back largely open and added vent holes in the floor of the tray to allow good air flow for the SSD's.
I wanted a place to hide all the USB thumb drives, SD cards, and other accessories that usually sit scattered on my desk.
The unit measures 6 inches by 6 inches and 2 inches in height. It turned out perfect for my needs.
One note, I designed the spot for the USB Hub to be a little bit loose. To lock it in place, I put a small piece of the soft side of some self-adhesive velcro stripping on the top. This gives just enough resistance to hold it snug, but still allow easy removal if needed.
| Mac_Studio_Accessory_Cabinet.stl | 100.3KB | |
| Mac_Studio_Accessory_Drawer.stl | 29.8KB |
