AOS 5 V5 & EVO Antenna Mount For Single Antenna Walksnail And Foxeer Lollipop 4 3D Printer Model
The file 'AOS 5 V5 & EVO Antenna Mount For Single Antenna Walksnail And Foxeer Lollipop 4 3D Printer Model' is (stl,3mf) file type, size is 23.7MB.
The file 'AOS 5 V5 & EVO Antenna Mount For Single Antenna Walksnail And Foxeer Lollipop 4 3D Printer Model' is (stl,3mf) file type, size is 23.7MB.
This is (yet) a(nother) FPV antenna holder for the AOS 5 V5 and EVO frames that aims to minimize adverse vibration.
I was tired of my vibrating antenna messing up my tune. I found an existing design by user Provalone3000. But this was for the O3 system. I just adjusted it to fit single antenna Walksnail systems. So all the props go to the original author.
All versions should fit the AOS 5 V5 and the AOS 5 EVO. But I only have the EVO to test.
There is a shorter version for the Walksnail stock antenna, as well as a version that I did to fit the wider top of the Foxeer Lollipop 4 (86mm) antenna. Because the cable of that antenna doesn't like to be bent, it needed to be longer as well. There is also a “simple” version without struts, that can be printed without (most) supports (brim suggested).
Print in PETG or hard TPU. I printed mine in PETG.
My settings were:
Does it work for you? Need another length? Feedback is welcome.
| AOS5_EVO_Lollipop4_Antenna_Mount.stl | 16.4MB | |
| AOS5_EVO_Lollipop4_Antenna_Mount_simple.stl | 5.8MB | |
| AOS5_Lollipop4_Antenna_Mount.3mf | 4.4MB | |
| AOS5_WS_Antenna_Mount.3mf | 4.3MB | |
| AOS5_WS_Antenna_Mount.stl | 16.1MB |
