please check out my Upgrade, Settings (Cura) Guide for the Anycubic: Guide
schaut mal bei meiner Anleitung für jegliche Verbesserungen, Tipps und auch Einstellungen (Cura) vorbei: Anleitung
This is a Filament Spool holder for the Anycubic I3 Mega.
Its very strong and doesn´t bend in any direction.
I added a cylinder so the spool runs smother.
I also removed the filament guide, because i had some problems with it.
Put the filamentholder on the right side of the printer. Clamp it at the bottom (below the 2 upper screws, like on the picture)
Use the pipe form the original spool holder, and push it trough the filament holder. Put the little plug left, the big right.
I have designed another filament Sensor holder, which works perfectly with this filament Spool holder:
https://www.thingiverse.com/thing:3404001
This is a remix of the great Anycubic i3 Mega Spool Holder by philwild.
| bigrightplug.stl | 78.8KB | |
| cylinder.stl | 936.5KB | |
| filamentholder.stl | 281.2KB | |
| littlenleftplug.stl | 60.5KB |
