Anti-Wobble Bearing For Geetech I3 3D Printer Model
The file 'Anti-Wobble Bearing For Geetech I3 3D Printer Model' is (stl) file type, size is 246.2KB.
The file 'Anti-Wobble Bearing For Geetech I3 3D Printer Model' is (stl) file type, size is 246.2KB.
Here is an Anti-Wobble Adapter for the Geetech i3 that uses Bearings.
Needed:
(for each axis - so double this)
3 - 8x4x3mm Bearings. 8mm outside diameter 4mm width 3mm inside diameter
3 - M3 x 16mm bolts - Cap Allen
3 - M3 Nuts - Standard
Once assembled, test the bearing out on the axis. It should be tight, but move relatively freely. If it is too tight, you can use a heat gun (maybe hair dryer) of some sort to warm up the bearing part of the assembly. Do this while the bearing is on the axis.
| Geetech_i3_Z-Stabilizer_bearing.stl | 624.0KB |
