Made this as 2 of my doors kept slamming and bumping shut in the wind.
Print the Door Mount on its back (hole facing upwards) and the Floor Mount on its side (Hold facing sideways).
Mounted them onto the door and floor using this TAPE, as command strips immediately gave out and these were the MAGNETS I used.
(The design is made so they protrude slightly for a better hold, the connection isn't the strongest and can still be pulled apart with a slight bit of force but will hold against knocks and the wind).
| Magnetic_Door_Holder_Door_Mount.stl | 34.2KB | |
| Magnetic_Door_Holder_Floor_Mount.stl | 29.6KB |
