Another Filament Runout Sensor Mount For Ender 3 V3 SE 3D Printer Model
The file 'Another Filament Runout Sensor Mount For Ender 3 V3 SE 3D Printer Model' is (stl) file type, size is 8.4KB.
The file 'Another Filament Runout Sensor Mount For Ender 3 V3 SE 3D Printer Model' is (stl) file type, size is 8.4KB.
If you buy the filament runout sensor shown in the photos above (3 pins to 3 pins), and have an Ender 3 V3 SE, and want to mount the sensor at the print head - this is the mount you want. Requires no screws or inserts, but I recommend using M3 x 12mm screws to attach to the print head. If you don't have those, you can use two of the M3 screws that came with the sensor.
This mount is for this sensor:
CREALITY 3D Original High Quality Filament Defect Sensor Module Kit for Ender-3 V2/CR-6 SE/Ender-3 S1/Ender-3 S1 Pro Printer
NOTE FOR INSTALL The 3 wire to 3 wire cable needs modification. See photo above - you must swap pins and cut the connector to make it fit. You can use a needle or knife tip to push the pin tabs down and pull them out. The 5V (red) and GND (black) wires must be swapped if you're using this particular sensor. Not the blue LED will not come on when wired this way, but your printer will properly sense filament and allow you to resume printing after.
If you wire it up, and the blue light is on, or it shuts down when triggering the sensor, it's not wired correctly!
BOARD 5V - Sensor GND
BOARD GND - Sensor 5V
BOARD SIG - Sensor Signal
BOARD 24V - Not Connected
| filament_sensor_v0.stl | 46.6KB |
