This garage is specially made for Anki Overdrive 4 car charger pod which can be glued to the garage floor using double sided tape.
Everything else should be either press fit or groove fit.
For the roof windows and main door glass I used transparent PLA so you can see easily if the cars are charging, however any PLA would work
For this project I used as initial model, wytewydow's Diecast Garage 4-Bay w/door which can be found @ https://www.thingiverse.com/thing:3631352
| bottom_door_glass.stl | 81.8KB | |
| garage_door.stl | 250.8KB | |
| roof.stl | 21.7KB | |
| short_Building.stl | 219.7KB | |
| short_Garage_floor.stl | 74.1KB | |
| short_Glass_roof.stl | 6.9KB | |
| top_doot_glass.stl | 81.8KB |
