These animals are native to the Eastern Washington region. Use these stamps to make animal tracks in clay or other malleable surfaces. They are relative in size and represent actual sizes to the real world animals.
I made 3 categories of stamp sizes to save on filament and time:
Small Stamps (30mm):
+Marmot
+Cottontail Rabbit
+Raccoon
Medium Stamps (50mm):
+Porcupine
+Skunk
+Turkey
Large Stamps (100mm):
+Coyote
+Deer
+Moose
Note: The Stamp Holders work better with supports, it only adds a little bit of support. Our Prusa was able to print without supports but it had a little bow towards the center.
| CottontailRabbit-Stamp-30mm.stl | 43.3KB | |
| Coyote-Stamp-100mm.stl | 310.3KB | |
| Deer-Stamp-100mm.stl | 122.4KB | |
| Marmot-Stamp-30mm.stl | 208.0KB | |
| Moose-Stamp-100mm.stl | 121.8KB | |
| Porcupine-Stamp-50mm.stl | 111.5KB | |
| Raccoons-Stamp-50mm.stl | 223.2KB | |
| Skunk-Stamp-50mm.stl | 171.4KB | |
| Turkey-Stamp-50mm.stl | 64.9KB | |
| _StampHolder-102.5mm.stl | 29.8KB | |
| _StampHolder-32.5mm.stl | 30.3KB | |
| _StampHolder-53.5mm.stl | 32.9KB |
