Angled HDZero Goggle Rail Adapter For TrueRC Patch Antenna 3D Printer Model
The file 'Angled HDZero Goggle Rail Adapter For TrueRC Patch Antenna 3D Printer Model' is (stl) file type, size is 111.5KB.
The file 'Angled HDZero Goggle Rail Adapter For TrueRC Patch Antenna 3D Printer Model' is (stl) file type, size is 111.5KB.
This is an angled adapter for mounting the TrueRC X-AIR 5.8 MKII patch antenna to the rail of the HDZero goggles. This adapter firmly secures the antennas at a 20 degree upward angle without the need for adhesives.
To install the antenna in the adapter, carefully guide the patch antenna housing in from the side, making that the cable aligns with the strain relief cutout. There are three bumps that keep the antenna housing from sliding out when installed that will require slight pressure to overcome during installation.
| patch_antenna_mount_rev_d.stl | 330.6KB |
