Anet AM8 A8 Extruder Carriage And Mount 3D Printer Model
The file 'Anet AM8 A8 Extruder Carriage And Mount 3D Printer Model' is (FCStd,stl) file type, size is 2.2MB.
The file 'Anet AM8 A8 Extruder Carriage And Mount 3D Printer Model' is (FCStd,stl) file type, size is 2.2MB.
• Direct replacement for the original Anet A8 MK8 extruder mount
• Extra 1 cm on Z height
• 200 grams less than the original mount
• Uses original parts
• You will also need 2 more M3x18 bolts and 4 M3 nuts (2 nuts are for 5015 fan)
• For sensor use another 2 M3x18 bolts with nuts
• You will need to lower Your Z axis endstop
• Version for 38,3 mm distance between X axis rods (~46mm from center to center)
• If you have a problem with inserting the nuts into the mount, you can heat them up with a lighter and they'll fit ok
• The fan duct is larger than the A8 original and is efficient enough imo
• The "teeth" in the fan duct are just supports and should be removed after print
• Use filament type which does not shrink, like PLA, PET, ABS-T. ABS is not recommended
• freeCad file included so You can make Your own mods
Log
2019-10-21 > 12 mm diameter capacitive sensor mount (Sensor Mount Type 2.stl)
2019-03-17 > minor changes, strenghtening the part with the extruder screw
2019-02-22 > Final version
2019-02-14 > Fan duct
2019-02-10 > Files created, carriage and inductive sensor mount (Sensor Mount Type 1.stl)
| Anet_AM8_A8_extruder_carriage.FCStd | 2.1MB | |
| Anet_AM8_A8_extruder_carriage.stl | 498.6KB | |
| Anet_AM8_A8_fan_duct.stl | 16.7KB | |
| Sensor_Mount_Type_1.stl | 63.3KB | |
| Sensor_Mount_Type_2.stl | 162.7KB |
