Anet A8: Tool Holder 2 (Right Side) 3D Printer Model
The file 'Anet A8: Tool Holder 2 (Right Side) 3D Printer Model' is (stl) file type, size is 74.9KB.
The file 'Anet A8: Tool Holder 2 (Right Side) 3D Printer Model' is (stl) file type, size is 74.9KB.
This is for the remaining tools (clipper and spanner) and like the other side, uses existing holes in the Perspex.
NOTE: In order to use these holes, you have to unmount the power supply and one screw needs to go in the other way round, so that the cross head is behind the power supply, so the power supply can fit back in place.
When you put the power supply back on, put 2 washers on each of the 3 screws that secure it, between the acrylic and the supply (like spacers) so it sits evenly. This is actually better, because it allows the power supply to not get too hot, and the heat won't transfer to the plastic frame, affecting your prints.
Cura settings:
Print upsidown. No support needed.
Tool holder for the other side is here:
http://www.thingiverse.com/thing:2072360
| my_tool_2.stl | 828.9KB |
