Anet A8 Threaded Rod Bracket With Slots For M4 Or #10 Pan/round Head Screws 3D Printer Model
The file 'Anet A8 Threaded Rod Bracket With Slots For M4 Or #10 Pan/round Head Screws 3D Printer Model' is (stl) file type, size is 549.0KB.
The file 'Anet A8 Threaded Rod Bracket With Slots For M4 Or #10 Pan/round Head Screws 3D Printer Model' is (stl) file type, size is 549.0KB.
Same hold-down/alignment clamp as https://www.thingiverse.com/thing:2390954 but this one has slots for M4 or #10 round-head screws instead of countersunk holes for flat-head screws.
Why slots? After mounting your printer to a surface, you should check your Y-axis to X-axis alignment by printing a large square and seeing that all four corners have right angles. I did this and noticed that two of the corners were about 89 degrees and the other two were about 91 degrees, i realized that I needed to push the front of my printer about 3mm to the left, in order to make the Y-axis perfectly perpendicular to the X-axis.
| M8_Rod_Base_Clamp_with_slots_for_10_pan_head.stl | 1.7MB |
