Yet another holder for the RepRapDiscount Full Graphic LCD (http://www.gearbest.com/lcd-led-display-module/pp_228315.html)
The spacer should be printed 4 times for the LCD-Sandwich PCB.
There is a hole in the front panel for the contrast potentiometer.
The Display holder uses the original LCD holes in the Anet A8 frame.
You should add a 470-560 Ohm resistor between Pin2 and Pin3 (of the LCD) to improve the contrast range.
To use the Display on the Anet A8 printer you have to make a simple adapter and change some firmware settings in the Skynet3D firmware "pins_ANET_10.h" : http://www.thingiverse.com/thing:2103748
Attention: Print height is reduced to approx 19cm!
If you don't want to lose build height just use the bottom holes and screw them in the top holes of the frame.
| A8_ramps_GLCD_encoder_knob.stl | 412.2KB | |
| A8_ramps_GLCD_frame_holder_left.stl | 133.9KB | |
| A8_ramps_GLCD_frame_holder_right.stl | 133.9KB | |
| A8_ramps_GLCD_front.stl | 284.5KB | |
| A8_ramps_GLCD_reset_knob.stl | 431.3KB | |
| A8_ramps_GLCD_spacer.stl | 35.2KB |
