Anet A8 Gothic Z Frame Brace 3D Printer Model
The file 'Anet A8 Gothic Z Frame Brace 3D Printer Model' is (skp,stl) file type, size is 334.4KB.
The file 'Anet A8 Gothic Z Frame Brace 3D Printer Model' is (skp,stl) file type, size is 334.4KB.
Anet A8 Frame Brace with a Gothic twist. Intended to help reduce the inherent wobble in the Anet A8 frame. It was printed up-side-down with a raft. The set pictured were printed with 35% infill, but I think 100% would be better. My intention is to bond them to the top frame so there isn't much to hold the top frame otherwise. The length of the "leg" can be adjusted to suit your particular setup. I've included the original Sketup file. The files I've included are Right Hand only. I just inverted it in Cura to get the left. One final little problem I need to fix is the Left Hand "leg" runs into one of my main board standoffs. Not sure how I'm going to address the set I've already printed but a notch could be modeled in. Good luck with it.
| Gothic_Z_Frame_Brace_RH.skp | 921.8KB | |
| Gothic_Z_Frame_Brace_RH.stl | 346.7KB |
