This is a final version of my Anet A8 frame upgrade that i have been working on. There have been multiple versions of this printer that I have uploaded to Thingiverse with slight changes to each one. This final version differs from the others in several different ways. Firstly, I was using 16mm M6 bolts which where slightly too long and they ended up bottoming out on the 3030 extrusion, I have changed the design so that it uses 14mm M6 bolts instead removing this issue from the design. Secondly, I have moved the Z Axis 3030 to the side of the Y Axis 3030 instead of on top. doing this brings back the ability to use all of the heated bed unlike some of my other iterations which didn't allow for full bed usage. Finally, i have moved the Y Axis end stop mounting point to allow the shorter rods to be used whilst maintaining the full 220mm of Y travel.
| Corner_Bracket_6.stl | 26.0KB | |
| Electronics_Box.stl | 195.5KB | |
| Electronics_Box_Lid.stl | 92.3KB | |
| Flat_Bracket_Left_3.stl | 37.2KB | |
| Flat_Bracket_Right_3.stl | 37.2KB | |
| PSU_Mount_2_NEW.stl | 60.2KB | |
| Y_Belt_Holder_Body.stl | 59.3KB | |
| Y_Belt_Holder_Clamp.stl | 31.9KB | |
| Y_Belt_Idler.stl | 94.0KB | |
| Y_Motor_Mount_Not_Stock_Endstop.stl | 70.1KB | |
| Y_Motor_Mount_Stock_Endstop.stl | 62.6KB | |
| Y_Rod_Holder_4.stl | 35.0KB | |
| Z_Axis_Corner_Bracket_4.stl | 27.0KB | |
| Z_Motor_Mount_Left.stl | 52.1KB | |
| Z_Motor_Mount_Right.stl | 52.1KB | |
| Z_Rod_Holder_Left.stl | 219.7KB | |
| Z_Rod_Holder_Right.stl | 219.7KB |
![Store Window Set [playfab 184002 – Playmobil Compatible] 3D Printer Model](https://cdn.3axis.co/assets/5f/21/3f/37/5f213f37-110b-45c5-bc3c-6e455644f7e2/images/549a5879-7b1c-4b5b-a507-2331fe7046c4_thumb.jpg)
