IMPORTANT: Get the latest updates for this model here on PrusaPrinters.
In 2021, all updates and uploads of new models were moved to PrusaPrinters, of course still free and under the same conditions... :)

Manual bed leveling the Anet A6/A8 is a little awkward and could be made a lot easier. There are some good solutions on the net - I took the best, made modifications and kept it simple.

This solution allows you to cover the entire hotbed with a build plate as you no longer need access to adjusting bolts from the build surface. All adjustment is done with the thumbwheels!

All metal! at the hot end - this allows you to heat up the bed for ABS, Nylon and other high temperature filaments without melting your bed level adjustment.

>> Don't forget, if you like it, please leave a like or a tip... :)

From the kit you will need:

• 4x Springs
• 4x Screw M3*30

Additional you will need:

• 8x M3 Nut (Optional: Use self-locking nuts for thumbwheels)
• 4x Steel/nylon M3 washer (Optional: I used large, but regular is OK)
• 4x Spring Cap (Print model)
• 4x Thumbwheel (Print model)
• A 3mm or 1/8" drill for stripping M3 thread

Note: To make this bed level upgrade, you need to strip the M3 thread in the Y carriage aluminum frame. This can not be reversed.

If your heatbed has copper traces under the washers, I recommend using nylon washers instead of metal to protect the heating element (eBay Search).

Just follow the photos to assemble.The M3 nuts is a tight fit in the thumbwheels to prevent them falling out.

2018 January 13.: Added thumbwheel for Nylock nuts.