Anemometer With Wind Direction 3D Printer Model
The file 'Anemometer With Wind Direction 3D Printer Model' is (stl,brd,sch) file type, size is 1013.9KB.
The file 'Anemometer With Wind Direction 3D Printer Model' is (stl,brd,sch) file type, size is 1013.9KB.
This is a model of the anemometer with wind speed and direction measurements. The whole can be mounted to a 40 mm pole.
Electronics inside contains 3 PCBs:
Special items needed:
2 stainless steel ball bearings SKF W 625-2Z
2 screws M5x35mm
2 secure nuts M5
4 small screws to mount the AS5048 to base and two small screws for fixing top and bottom parts together
The magnet for AS5048 is fixed on the M5 screw by pushing the head and the magnet to opposite holes in Round magnet spacer. The ball bearings are simply pushed to openings in the bottom and top base from top side. Gravity shall help to keep the bearings in place long-term.
| Anemo_bottom-AMS_spacer.stl | 91.5KB | |
| Anemo_bottom-Base.stl | 267.8KB | |
| Anemo_bottom-High_cap.stl | 576.8KB | |
| Anemo_bottom-Low_cap.stl | 175.1KB | |
| Anemo_bottom-Pole_mount.stl | 58.7KB | |
| Anemo_bottom-Round_magnet_spacer.stl | 125.9KB | |
| Anemo_bottom-Tip.stl | 145.6KB | |
| Anemo_bottom-Wing.stl | 2.6KB | |
| Anemo_top_-_Base.stl | 400.1KB | |
| Anemo_top_-_Cap.stl | 667.7KB | |
| Anemo_top_-_Interrupter.stl | 128.0KB | |
| Anemo_top_-_Wind_bowl.stl | 845.3KB | |
| Interbase.brd | 80.8KB | |
| Interbase.sch | 717.3KB | |
| Optical_sensor.brd | 48.9KB | |
| Optical_sensor.sch | 215.6KB |
