Anemometer – Wind Speed – Wind Direction 3D Printer Model
The file 'Anemometer – Wind Speed – Wind Direction 3D Printer Model' is (stl) file type, size is 1.1MB.
The file 'Anemometer – Wind Speed – Wind Direction 3D Printer Model' is (stl) file type, size is 1.1MB.
/ UPDATE 7/7/2022 - ADDED /
/ Anemo16.stl was missing /
/ picture on print position /
/ precision on post-print /
Anemometer v1.0 - Solar - Wifi - Bluetooth
For complementing with a single axis solar tracker you can see
https://www.thingiverse.com/thing:5385253
BOM
1 x ESP32 like Firebeetle, or ESP WROOM Lolin32 or LOLIN32 with ESP32 240MHz Dual-Core, WiFi, Bluetooth/BLE, 4MB Flash, Charging Circuit, Arduino IDE Compatible
1 x AS5600 Absolute Encoder PWM / I2C Port Precision 12-bit (wind direction)
2 x Ky 003 Magnetic Sensor Module DC 5 V (Wind Speed)
1 x INA3221 Triple Channel Shunt Power Supply Voltage Monitor Sensor
1 x Solar panel 12W 12v 20W or more recommended especially for winter saison in the north of Europe
4 x ball bearings 624Z 4 mm x 13 mm x 5 mm Single Row
2 x M4 40mm bolt + nolt
1 x Waveshare Solar Power Management Module for 6V~24V Solar Panel
3 x magnets for the wind speed
1 x magnet for the AS5600 encoder (wind direction) se the datasheet. In my case I used the magnet of a old defective RC chopper motor diameter 5mm
2 x 18650 (2 x 2000mA/h) Aku recycled from laptop battery pack
1 old usb cable of the desired length
6 x screws for the wind speed and direction
2 x threaded rod 80mm length
| Anemo1.stl | 90.4KB | |
| Anemo10.stl | 334.3KB | |
| Anemo11.stl | 209.0KB | |
| Anemo12.stl | 102.4KB | |
| Anemo13.stl | 5.2KB | |
| Anemo14.stl | 223.7KB | |
| Anemo15.stl | 22.9KB | |
| Anemo16.stl | 484.5KB | |
| Anemo2.stl | 365.9KB | |
| Anemo3.stl | 35.0KB | |
| Anemo4.stl | 49.3KB | |
| Anemo5.stl | 335.6KB | |
| Anemo6.stl | 28.5KB | |
| Anemo7.stl | 121.4KB | |
| Anemo8.stl | 600.9KB | |
| Anemo9.stl | 537.9KB |
