This is an Anderson PowerPole Polarity Checker to see if the power is correct or curcuit is Live.
I used the following:
PowerPole Shells - https://powerwerx.com/anderson-power-fingerproof-pp15-45-housings
PowerPole Contacts - https://powerwerx.com/anderson-1335g1-printed-circuit-board-vertical
5mm Bi-Polar LEDS - https://bit.ly/30k4UMm
330ohm Resistor
You will need to check the Polarity of the LED so that the Positive leg that gives you Green is on the Red PowerPole. Then you will cut that leg to 14mm. You cut the other leg to 4mm along as both legs of the resistor also cut to 4mm.
Then solder according to pictures attached and check device, then insert in housing.
Great for checking unknown power sources before plugging in expensive equipment. Also good for checking if the circuit is alive.
Enjoy
| APP_POLARITY_v4.stl | 925.1KB |
