Among Us Refrigerator Magnet 3D Printer Model
The file 'Among Us Refrigerator Magnet 3D Printer Model' is (stl) file type, size is 458.7KB.
The file 'Among Us Refrigerator Magnet 3D Printer Model' is (stl) file type, size is 458.7KB.
To achieve the multicolored print you will need a printer that supports M600 (filament change) G code or similar. You could also pause the print manually but that will require more patience.
The model uses one 10mm by 3mm neodymium magnet embedded inside the print. There are three pause points you will need to add in your slicing software to achieve the same result. Assuming you use 0.2mm layer height, in Prusa slicer I get:
1st pause at layer 16 to place the magnet
2nd pause at layer 27 to switch to gray filament
3rd pause at layer 31 to switch to black filament
You'll want to verify your pauses in slicing software by using different colors as shown in the pictures.
Enjoy! My kids love these.
Update: I purchased all my magnets from Amazon. Here's a link for magnets that would work for this particular build. Just be sure you are purchasing the correct size.
https://www.amazon.com/DIYMAG-Refrigerator-Magnets-Premium-Brushed/dp/B08HQMT9BD
| amongusmagnet.stl | 3.8MB |
