A mold for making candles.
This was a first test if this is a viable thing to do.
Candle making:
- Print the mold
- use Filler Spray on the inside
- sand the inside to get a smoth surface
- make the whole on the top wider to make it possible to insert molten wax later (did mess this up a little in the model)
- spray the insides of the mold with oil (WD40)
- put in candle wick
- close mold
- put tape around the edged
- secure mold with rubber bands
- insert molten wax
- wait for it to harden (fridge helps)
- open the mold and clean the model around the edges
Notes:
