This is a cradle with stand for Amazon Echo Dot v2. Cradle can be used alone without the base. The bell part inserts into the bottom of the base, this should be a good friction fit.
Minimum supports are needed when printing the cradle where there is a gap for the USB/Audio cables, otherwise no supports should be needed with proper layer cooling.
Set your extrusion width to 0.4mm to print this design.
UPDATE 1/5/2017: Added "cheesy" cradle
| Cheesy_Cradle.stl |
| Echo_Dot_V2_Base.stl |
| Echo_Dot_V2_Bell.stl |
| Echo_Dot_V2_Cradle.stl |
