I created and grouped some of these items by others in one place for use with the 2040 extruded frame update of the Anet A8. I was looking for items when I upgrade my frame so what I couldn't find I created. I have also added other things that I have put on my extruded frame, the linear rail covers are by Sheffdog. Raspberry Pi Mount is by pareppa, PSU mount is for 30A unit. Added mount for two small mosfets.
| 12864_Back.stl | 76.8KB | |
| 12864_Frame_Bracket.STL | 50.9KB | |
| 12864_Front.stl | 82.9KB | |
| 12864_Reset_Button.stl | 118.7KB | |
| CAMERA_MOUNT.STL | 18.4KB | |
| CAMERA_VERT_MOUNT.STL | 42.3KB | |
| CHANNEL_CAPS.STL | 129.2KB | |
| EXTRUDER_EXTENSION-5.STL | 57.1KB | |
| EXTRUGER_MOUNT.STL | 60.2KB | |
| Knob.stl | 906.5KB | |
| MAIN_BOARD_MOUNT.STL | 123.4KB | |
| MOSFET_MOUNT.STL | 187.5KB | |
| MOSFET_MOUNT_SMALL.STL | 186.6KB | |
| prusa_i3_x_belt_tensioner.stl | 176.0KB | |
| PSU_MOUNT.STL | 96.4KB | |
| PSU_SWITCH.STL | 87.6KB | |
| RAMPS2040MOUNT.STL | 171.6KB | |
| rpi2-bottom.STL | 326.2KB | |
| rpi2-top.STL | 189.8KB | |
| rpi_-_to_frame.STL | 179.5KB | |
| SPOOL_HOLDER_LEFT_REAR.STL | 136.0KB | |
| SPOOL_HOLDER_RIGHT.STL | 66.6KB | |
| SPOOL_HOLDER_RIGHT_REAR.STL | 139.6KB | |
| SPOOL_HPLDER_LEFT.STL | 65.9KB | |
| wireChannelE_long.stl | 6.5KB | |
| Y-AXIS_SWITCH_ROD_MOUNT.STL | 56.2KB | |
| Y-CHAIN_EXT_MOUNT.STL | 61.2KB | |
| Y_BELT_BLOCK.STL | 56.7KB | |
| Y_BELT_TENSIONER.STL | 162.4KB | |
| Z_MOTOR_MOUNT_LEFT.STL | 108.2KB | |
| Z_MOTOR_MOUNT_RIGHT.STL | 108.2KB |
