This is a combination of several files from thingiverse and outside sources.
Nativity.stl - Taken from (http://www.thingiverse.com/thing:186256). Print at 1/10th scale.
NativityStar_1cm.stl - Stretch it by 2.5 in the length and width directions. Scale it by 0.5 in the height direction
WisemenRevA.stl - Scale it by 0.35 in the length and width directions. Flip it over and stop the print before it gets to the solid back. Created with (http://3dp.rocks/lithophane/) from this image (http://www.clker.com/cliparts/O/1/f/3/B/a/three-wise-men.svg)
Isaiah_9_6.stl - Scale it by 0.35 in the length and width directions. I found that it was more clear if I stopped it about 1.3mm into the print. Created with (http://3dp.rocks/lithophane/).
Ornament_Hanger.stl
Print one of each and then glue into an Altoids Smalls container. Attach ornament holder and give as gift.
| Isaiah_9_6.stl | 7.7MB | |
| Nativity.stl | 392.2KB | |
| NativityStar_1cm.SLDPRT | 104.5KB | |
| NativityStar_1cm.STL | 3.0KB | |
| Ornament_Hanger.SLDPRT | 275.5KB | |
| Ornament_Hanger.STL | 375.0KB | |
| WisemenRevA.stl | 6.4MB |
