I needed a case for my FPGA so I started to make one. This one will fit the Altera Max 10 FPGA, but it still needs a bit of fine tuning. Ports might need to be adjusted and the end is just slightly off. I hope to have some time in a few months to get back to this. Until then see if it works for you. If there is something you think should be fixed message me and I'll add it to the tweek list. Cheers
| max10_final.skb | 192.6KB | |
| max10_final.skp | 192.6KB | |
| max10_final_ascii.stl | 41.0B | |
| max10_final_Bottom.skp | 176.4KB | |
| max10_final_Bottom.stl | 55.0B | |
| max10_final_top.skp | 174.5KB | |
| max10_final_top.stl | 49.0B |
