Version 2 of the Airwolf model. This model is based on the basic design by Hans Meyer at Grabcad, remixed, STL's fixed, updated, missing parts added.
The front fuselage needs to be printed heavier (30% infill) as opposed to the rear parts (5-15% infill) to ensure it doesn't tilt over backwards. Front Fuselage now has indents for the windows so you can print in clear or another color.
You can print this very little support only on some parts like the front fuselage and rear bottom fuselage part. Parts are labelled with the color they have to be printed in. At 100% scale the model is about 300mm long and 60mm high. When you print at 100% the rotors can spin.
Version 2 added guns also included the original rear fuselage part. Most parts now have alignment holes for strength and to make alignment simpler.
| Base_Half_labeled.stl |
| Black_Front_Fuselage.stl |
| Black_GunPod_L_Top.stl |
| Black_GunPod_R_Top.stl |
| Black_Rear_main_fuselage_Fix.stl |
| Black_Rear_main_fuselage_noguns_v1.stl |
| Black_Rear_Main_Fuselage_Top_Guns.stl |
| Black_Rear_Main_Fuselage_Top_Guns_repaired.stl |
| Black_Stabilizer_Left.stl |
| Black_Stabilizer_Right.stl |
| Black_Tail_Boom_Upper.stl |
| Black_Tail_Fin_Upper.stl |
| Clear_Front_Fuselage_Windows.stl |
| Grey_Front_Wheel.stl |
| Grey_Main_Rotor_Bottom_Core.stl |
| Grey_Main_Rotor_Bottom_Sides_x2.stl |
| Grey_Main_rotor_Cap.stl |
| Grey_Main_Rotor_Pin.stl |
| Grey_Main_Rotor_Pivot_Bottom.stl |
| Grey_Main_Rotor_Pivot_Top.stl |
| Grey_Main_Rotor_Top_Middle.stl |
| Grey_Main_Rotor_Top_Sides_x2.stl |
| Grey_Rear_wheel_x2.stl |
| Grey_Rocket_Launcher.stl |
| Grey_Tail_rotor_Cap.stl |
| Grey_Tail_Rotor_Left.stl |
| Grey_Tail_Rotor_Pin.stl |
| Grey_Tail_Rotor_Pin_Stop.stl |
| Grey_Tail_Rotor_Right.stl |
| White_Bottom_Main_Fuselage_Rocket_mount_place.stl |
| White_Gunpod_L_Bottom.stl |
| White_Gunpod_R_Bottom.stl |
| White_Rear_Main_Fuselage.stl |
| White_rear_main_fuselage_noguns_v1.stl |
| White_Rear_Tail_Boom_Bottom.stl |
| White_Rear_Tail_Fin_Bottom.stl |
