Airtag Mount For MTB Or Other Bike With ~32mm Hole. 3D Printer Model
The file 'Airtag Mount For MTB Or Other Bike With ~32mm Hole. 3D Printer Model' is (stl) file type, size is 6.4MB.
The file 'Airtag Mount For MTB Or Other Bike With ~32mm Hole. 3D Printer Model' is (stl) file type, size is 6.4MB.
Choose Bottom_lid with or without flange.
Add a m5 nut and a 15mm long countersunk m5 screw.
Mount the pieces together, sqeeze-ring in the middle, align drainage opening with sqeeze ring.
Thread in the screw.
Click in your Airtag silvery lid into the holder. If it is too tight, scrape with a a knife or similar on the inside of the rim until it has a snug but possible fit.
To remove it, just loosen the screw and pull in out of the fork!
To remove the airtag from the holder, use a longer screw to push it out
| Bottom_lid_32_flange.stl | 4.9MB | |
| Bottom_lid_32_noflange.stl | 5.5MB | |
| Middle_sqeezering_32.stl | 2.6MB | |
| Top_airtag_comp_32.stl | 6.7MB |
