Made a VSR10 to M4 magazine adapter. I've had a couple of requests for one. Print with supports enabled and watch out to not cut the pivot point when removing the support structure on the mag release part. I used a spring from a pen and cut it in half to use to put tension on the mag release part.
I've uploaded new updated files that hold the mag in better and is more reliable. Everything is 3d printable except the part that holds in the release lever. I used a nail that has flat head with a 2.48-2.5 mm diameter shaft and cut it with some wire cutters for length and fit. Make sure there is no support structure in the feed tube. Used 0.3mm for the adapter and 0.2mm for the release lever and spring. Make sure there is no debris in the feed tube before using.
| Lever.stl | 14.9KB | |
| Spring1.stl | 2.4KB | |
| Spring2.stl | 2.4KB | |
| VSR10MagAdapter.stl | 64.5KB | |
| VSR10MagAdapter2.stl | 62.4KB |
