Airsoft Protector For Bushnell TRS-25 3D Printer Model
The file 'Airsoft Protector For Bushnell TRS-25 3D Printer Model' is (stl) file type, size is 210.7KB.
The file 'Airsoft Protector For Bushnell TRS-25 3D Printer Model' is (stl) file type, size is 210.7KB.
Little thingy to hold a small disc of Polycarbonate in front of your red dot to stop BBs from cracking your lens. I highly recommend using an impact resistant type of resin/filament.
Requirements:
Polycarbonate Sheet (3mm thick cut into discs with 28mm diameter)
M4 Bolt and Nut (10mm bolt best)
Instructions:
Final update: I printed and used this for a 3-day milsim and experienced no issues. It held onto the sight perfectly. That said, it didn't take any direct hits.
Based on some testing after the game, you can expect it to hold up to lower-joule shots, but if you get hit in the sight by a sniper, or at a bad angle, the ring will likely shatter, so bring backups!
| Poly_Sizer1.stl | 20.4KB | |
| SightProMk2_DONE.stl | 515.9KB |
