Airsoft Novritsch SSG10 Rifle Suppressor Inner Barrel Spacer 3D Printer Model
The file 'Airsoft Novritsch SSG10 Rifle Suppressor Inner Barrel Spacer 3D Printer Model' is (stl) file type, size is 31.2KB.
The file 'Airsoft Novritsch SSG10 Rifle Suppressor Inner Barrel Spacer 3D Printer Model' is (stl) file type, size is 31.2KB.
This is a barrel spacer for the Novritsch SSG10 Rifle Suppressor for when you use the Short Outer Barrel and the standard length (long) Inner Barrel.
Need 4 O-rings:
(Quantity of 2) #6 O-rings { O.D. 7/16" I.D. 5/16" WALL 1/16" } for the inner barrel grooves. (Quantity of 2) #27 O-rings { O.D. 1-1/8" I.D. 7/8" WALL 1/8" } for the outer barrel grooves.
Install the O-rings (will be a tight fit).
Slide this barrel spacer all the way down into the empty Rifle Suppressor until it bottoms out (this will also be a tight fit and you'll need a stick to fully push the spacer in).
Using the SSG10 Suppressor Adapter that is threaded into the end of your barrel, thread on the Novritsch Rifle Suppressor (make sure to carefully guide the inner barrel through the barrel spacer inner O-rings).
Install the foam discs in front of the barrel spacer inside of the suppressor in any order you like.
(You will now have leftover foam discs that will no longer be used.)
(I used 1 small hole disc first and then used the large hole discs for the rest of it.)
Using this suppressor inner barrel spacer resulted in extreme accuracy while reducing the noise levels!
Enjoy!
| Airsoft_Novritsch_Rifle_Suppressor_Barrel_Spacer.stl | 152.4KB |
